![]() ![]() These are very common, and are among the most effective spring mods. Spring additions are the additions of other springs into the blaster. ![]() Additionally, most factory springs are already heat-treated and reheating them will usually ruin the spring. ![]() It is theoretically possible to temper the spring using a relatively low temperature to make it slightly more ductile and thereby more useful, but this is a difficult process that is best left to experts. In fact, while heat-treating and quenching the spring might make it stronger, it will likely also make it more brittle. However, spring heating is very dangerous and has not been proven to increase the performance of a blaster. Using a blowtorch, springs are heated up to supposedly increase stiffness and improve the performance of the spring. It is recommended not to use this method. This method is proven not to help blasters, as it wears out the spring more over time, causing it to compress more than it should have. Spring stretching is a method which is used on some springs, usually in the case that the owner does not have a replacement spring to use instead. Some blasters such as the Game Face Trion come with their own spring spacers to adjust the power of the blaster. This is the easiest to do on a reverse plunger direct plunger systems usually have a plunger rod that would interfere with objects placed behind the spring and not allow the blaster to be primed all the way. If the spring is compressed too much, the plunger will be off-track and will not fire completely. However, it is not without its downsides it may cause the blaster to be harder to prime, and will cause the spring to weaken over time, since it is compressed even when unprimed. This method is very effective for increasing the power of a blaster. Doing this will allow the spring to release at higher speeds, causing the plunger to fire faster. Spring compression is when objects like coins, small pieces of cardboard, or 3D-printed spacers are placed behind a spring to compress it from behind. Some of the more notable forms of modification include: There are several types of spring modification, most of which involve the addition of another spring. Of course, as a common mechanical component, small springs are commonly found in other parts of blasters such as triggers, catches, etc. This is where two springs are placed inside the blaster to provide double the power. The most common spring modification is double springing the blaster. Springs are usually made of an alloy, such as an iron/carbon or iron/chromium/nickel alloy so that the metal doesn't rust and render the spring useless. the Retaliator and Alpha Trooper CS-12 share a similar spring, but usually springs are proprietary. There are some standard sizes of springs, e.g. As a result, some springs aren't compatible with certain Nerf products. Stock springs that come with Nerf blasters are all unique. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |